The usage of Bricks or Pavers to develop a sidewalk or patio area complements a home in a method that is unrivaled. In addition, setting up a Brick or Paver pathway does not always require a pro.
The key to installing a Brick or Paver Walkway is to very first appropriately prepare the location where the bricks/pavers are to be set up. In addition, string lines should be strung on each side of the walkway.
As soon as the area has actually been dug down, 3/4" gravel stone must be laid in and tamped down firmly. Then 2" of sand, or stone dust should be topped the gravel. Again the sand/stone dust must be tamped down. Stone dust is preferred. The height between the tamped down sand and the stringline must equate to the thickness of the brick or paver.
Now that you have a steady base, position a 1" pipe or ledger board the length of the pathway on either side of the pathway. Using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will create a level surface location to lay the bricks/pavers.
Now location on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the prepared area. These strips will act as your pathway border and aid to maintain the stability and shape of the sidewalk.
You can then begin to lay the bricks/pavers when this is done. There are numerous patterns you can lay. I especially like the Herring Bone pattern. The key to laying the bricks/pavers is to make sure that more info they interlock with each other. Constantly stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will once again help preserve the stability of the sidewalk.
Undoubtedly bricks/pavers will require to be cut or split when developing the pathway. Unless you wish to purchase or rent a costly wetsaw, I would recommend purchasing a basic brick/paver splitter. It is basically a sculpt with a wide end that is the width of the bricks/pavers. To actually cut/split the brick/paver, lay it in a bed of sand and place the sculpt at a 75 degree angle over the spot where you wish to break the brick. Then using a hammer strike the butt end of the chisel firmly. You might need to do this a number of times. You may also wish to flip the brick/paver over and strike the opposite of the brick using the hammer and chisle. Within one or 2 strikes the brick/paver need to break easily. , if your pathway has curves you will need to buy/rent a wetsaw.
.
After installing the bricks, build up the outside edges with additional sand, and then shovel in the topsoil and pack down securely.
Spread stone dust over the new pathway and sweep into the cracks. This will complete the interlocking of the bricks and assist to eliminate any weed development.
In addition, installing a Brick or Paver sidewalk does not necessarily require a pro. The secret to setting up a Brick or Paver Walkway is to very first correctly prepare the location where the bricks/pavers are to be installed. Now that you have a stable base, position a 1" pipeline or ledger board the length of the walkway on either side of the walkway. These strips will act as your pathway border and aid to maintain the stability and check here shape of the pathway. Inevitably bricks/pavers will require to be cut or divided when constructing the sidewalk.